|
22-19-ruchka-perednejj-dveri.html
22.19. The handle of a forward doorRemoval
Remove a door upholstery.
Remove an arm from a door.
Disconnect draughts from the cylinder of the lock and the door handle.
|
|
Fig. 16–34. The handle of a forward door: 1 – a rotary clip; 2 – the door handle; 3 – a bolt, 5 Нм; 4 – a lock ring (on models till 02.96) or a clip (on models from 02.96); 5 – driving the lever; 6 – a spring; 7 – a casing; 8 – a plate; 9 – a decorative overlay of the handle; 10 – a sealing ring; 11 cylinder of the lock
|
Insert a key into the cylinder of the lock of a door and remove a lock ring 4 and a rotary clip 1 (fig. 16–34 see) from the lock cylinder.
Remove from the lock cylinder driving the lever 5 and a spring 6. Take the lock cylinder together with a key and remove a casing 7.
Unscrew a bolt of 3 fastenings of the handle of a door.
|
|
Fig. 16–35. Removal of a fixing strip of an overlay of the handle of a door
|
Small screw-driver squeeze out a fixing strip of an overlay of the handle of a door and remove an overlay (fig. 16–35).
Installation
Installation is spent to sequences, return to removal, taking into account the following.
|
|
Fig. 16–36. An arrangement of the ends of a spring (1) from two parties of a ledge driving the lever (2)
|
At spring installation compress it and arrange the ends from the left and right party of a ledge driving the lever (fig. 16–36). Preliminary compression of a spring provides return driving the lever in average position.
|
|
Fig. 16–37. Combination of half of tooth on the lever and a half a tooth on a gear wheel of a drive of the microswitch
|
Establish driving the lever so that half of tooth on the lever was combined and a half a tooth on a gear wheel of a drive of the microswitch (fig. 16–37). It provides normal functioning of anticreeping system and system of the central blocking of the lock.
|