|
21-15-rychag-stoyanochnogo-tormoza.html
21.15. The lever of a lay brakeRemoval
On all-wheel drive cars remove back section of system of release.
|
|
Fig. 15–38. An arrangement of bolts of fastening of a flange карданного a shaft to the main reverse gear and screws of fastening of a thermofilter
|
Turn away screws and remove the central thermofilter (fig. 15–38 see).
|
|
Fig. 15–33. The lever of a lay brake: 1 – a decorative overlay; 2 – facing of the lever of a lay brake; 3 – a cover; 4 – the central console; 5 – a washer; 6 – the screw; 7 – the lever of a lay brake; 8 – the handle; 9 – the self-cutting screw; 10 – the switch of a control lamp of a lay brake; 11 – a lock ring; 12 – a spring; 13 – a protective cover; 14 – шарнирный a finger; 15 – the jack; 16 – the plug; 17 – an adjusting nut; 18 – шарнирный a finger; 19 – a clip; 20 – a bolt, 5 Нм
|
|
|
Fig. 15–34. Unscrewing of an adjusting nut of fastening of the jack and an arrangement of the springs fixing covers of cables of a lay brake
|
Unscrew an adjusting nut of fastening of the jack to draught of the lever of a lay brake (fig. 15–34), remove the plug and the jack.
Remove from draught of the lever of a lay brake a protective cover.
Remove the central console.
|
|
Fig. 15–35. Elements of fastening of the lever of a lay brake: 1 – a bolt; 2 – a clip; 3 – a lock ring
|
Unscrew a bolt 1 and remove a clip 2 (fig. 15–35).
Remove a lock ring 3 with swivel a finger and squeeze out шарнирный a finger.
A little move the lever of a lay brake to a back part and remove it.
Installation
Installation is spent to sequences, return to removal, taking into account the following.
Before lever installation put on all mobile connections greasing G 000 150.
Establish a lock ring and check up reliability of fastening swivel a finger.
Establish a protective cover.
Check up, that the system has been established freely, without pressure, with a sufficient backlash from body elements.
|