|
24-13-fary.html
24.13. Headlights
|
|
Fig. 18–33. A headlight with галогенной a lamp: 1 – the headlight case; 2 – a lamp of antifog headlight H3 (12 V, 55 W); 3 – a 5-contact electric socket; 4 – a back cover of a headlight; 5 – a headlight lamp; 6 – a lamp of passing light H1 (12 V, 55 W)
|
The device of headlights with галогенной and gas-discharge lamps is shown on fig. 18–33 and 18–34.
|
|
Fig. 18–34. A headlight with a gas-discharge lamp: 1 – a rubber overlay; 2 – headlight glass; 3 – a clip; 4 – a lining; 5 – a reflector framework; 6 – a reflector; 7 – a headlight lamp (12 V, 65 W); 8 – a lamp a lobby dimensional (12 V, 5 W); 9 – a lamp of an antifog headlight (12 V, 55 W); 10 – a passing light lamp (gas-discharge 12 V, 35 W); 11 – the spring holder; 12 – the block of management of a headlight with a gas-discharge lamp; 13 – a Torx-bolt; 14 – a back cover; 15 – a plastic washer; 16 – a bolt; 17 – a lining; 18 – the engine of the proof-reader of light of headlights; 19 – consolidation; 20 – a clamp arm; 21 – the headlight case; 22 – the block of activation of a gas-discharge lamp; 23 – a Torx-bolt; 24, 25 – plaits of wires
|
Removal
Stick with a sticky tape a bumper about a headlight not to damage bumper colouring.
Unscrew bolts of fastening of a forward bumper and push it forward from an arm on 5-10 see
Remove turn indexes.
Disconnect from a headlight a 5-contact electric socket of a plait of wires of a headlight.
|
|
Fig. 18–35. Elements of fastening of a headlight: 1 – the screw; 2 – the bottom overlay; 3 – a bolt of fastening of a headlight
|
Unscrew the screw 1 (fig. 18–35) and remove an overlay of 2 headlights.
Unscrew four bolts 3 and take a headlight forward from the car.
Installation
Establish a headlight on the car in such position that the backlash on headlight perimetre was identical.
The further installation is spent to sequences, return to removal.
Check up and if necessary adjust light of headlights.
|