|
3-8-datchik-chastoty-vrashheniya-dvigatelya.html
3.8. The gauge of frequency of rotation of the engineThe arm of the gauge of frequency of rotation of the engine can move at the expense of the extended apertures. Arm position is adjusted and cannot change.
If by mistake bolts of fastening of an arm unscrewed also an arm moved, establish it into place as follows.
Turning a cranked shaft of the engine in a direction of its working rotation for a bolt of fastening of a pulley of a cranked shaft, establish the piston of the first cylinder in ВМТ.
|
|
Fig. 3.1–51. Label combination on a pulley of a cranked shaft () with the index () on a casing
|
Be convinced that the label on a pulley of a cranked shaft was combined with the index on a casing (fig. 3.1–51 see).
|
|
Fig. 3.1–53. An arrangement of the adjusting screw 3242 for fixing of a cranked shaft
|
Turn out the gauge of the moment of ignition from an arm. Instead of the gauge of the moment of ignition screw the adjusting screw 3242 (fig. 3.1–53 see).
|
|
Fig. 3.1–69. Use of the special tool 3308 (1) for combination with a gear wreath of a flywheel
|
Turn out bolts of fastening of the gauge of frequency of rotation of the engine and remove it. Instead of the gauge of frequency of rotation establish the special tool 3308 (fig. 3.1–69) so that it was combined with a gear wreath of a flywheel.
Tighten the demanded moment bolts of fastening of an arm of the gauge of the moment of ignition.
The further installation is spent to sequences, return to removal.
|