|
3-12-levaya-kryshka-golovki-bloka-cilindrov.html
3.12. The left cover of a head of the block of cylindersThe prevention
All clips and collars which at removal of a cover of a head of the block of cylinders will be damaged or cut, at installation of a cover of a head of the block of cylinders it is necessary to replace with the new.
Removal
|
|
Fig. 3.1–7. An arrangement of protective casings (1–4) in a back part of a motor compartment
|
Turn away four screws and remove an engine casing (fig. 3.1–7 see).
The cars equipped with system of the cruise-control
|
|
Fig. 3.1–14. An arrangement of draught of management (1), nuts of fastening (2) vacuum blocks and a vacuum hose (3)
|
Disconnect draught of management 1 (fig. 3.1–14 see) from the vacuum block.
Remove from the vacuum block a vacuum hose 3.
Turn away a nut 2 and remove the vacuum block.
Disconnect a ventilation hose картера from a cover of a head of the block of cylinders.
Release a vacuum hose of the vacuum amplifier of brakes from clamps.
Disconnect a rope and take him aside.
|
|
Fig. 3.1–82. An arrangement of bolts of fastening of the left cover of a head of the block of cylinders
|
Turn away fastening bolts (fig. 3.1–82) and uncover heads of the block of cylinders.
Installation
Installation is spent to sequences, return to removal, taking into account the following.
If necessary replace a lining of a cover of a head of the block of cylinders.
At cover installation on basic surfaces of extreme covers of a camshaft apply a thin film hermetic D 454 300 And, thus do not block an aperture for oil giving.
Before lining installation spray on its both parties silicon greasing D 007 000 A2.
Bolts of fastening of a cover of a head of the block of cylinders tighten gradually on a diagonal.
|