|
3-6-dvukhmassovyjj-makhovik.html
3.6. A two-mass flywheelRemove a transmission.
Turning a cranked shaft of the engine in a direction of its working rotation for a bolt of fastening of a pulley of a cranked shaft, establish the piston of the first cylinder in the top dead point (ВМТ).
|
|
Fig. 3.1–51. Label combination on a pulley of a cranked shaft () with the index () on a casing
|
Be convinced that the label on a pulley of a cranked shaft was combined with the index on a casing (fig. 3.1–51 see).
|
|
Fig. 3.1–53. An arrangement of the adjusting screw 3242 for fixing of a cranked shaft
|
Fix a cranked shaft in this position. For fixing of a cranked shaft turn out from the block of cylinders the gauge of the moment of ignition and instead of it screw in the adjusting screw 3242 (fig. 3.1–53 see).
Unscrew bolts and, being careful, remove a flywheel.
Establish a flywheel in sequence, return to removal, thus it is necessary to use new bolts of its fastening. The moment of a tightening of bolts of fastening of a flywheel: 60 Нм + to tighten on a corner 180 .
|