|
6-4-poliklinovyjj-remen.html
6.4. A poliklinovyj beltThe poliklinovoj belt carries out a drive of the generator, the pump of the amplifier of a steering, the fan of a radiator, the compressor of the conditioner and the water pump depending on engine updating.
Removal
Preventions
Before removal by a chalk, a marker or a paint note a rotation direction semi wedge a belt. If at installation were in the use semi wedge a belt, it rotates in other party, it will lead to its destruction. Be convinced that полиwedge the belt is correctly located on pulleys.
It is forbidden to open a contour of a coolant of a central air of air.
The note
|
|
Fig. 3.4–24. The units put in action поликлиновым by a belt: 1 – полиwedge a belt; 2 – a casing; 3 – a bolt, 22 Нм; 4 – a bolt, 45 Нм; 5 – a bolt, 45 Нм; 6 – the generator; 7 – the tension mechanism semi wedge a belt; 8 – a bolt, 22 Нм; 9 – гаситель fluctuations with a pulley semi wedge a belt; 10 – a bolt, 22 Нм; 11 – a nut, 22 Нм; 12 – aligning plugs; 13 – an arm of the compressor of the conditioner and the pump of the amplifier of a steering; 14 – a bolt, 40 Нм; 15 – a bolt, 22 Нм; 16 – the pump of the amplifier of a steering; 17 – an adjusting lining; 18 – the aligning plug; 19 – a pulley of the pump of the amplifier of a steering; 20 – a bolt, 22 Нм; 21 – the conditioner compressor; 22 – a directing roller semi wedge a belt; 23 – a bolt, 22 Нм; 24 – a cover of a directing roller
|
Adjusting linings 17 (fig. 3.4–24) happen a various thickness and serve for adjustment соосности a pulley and semi wedge a belt.
Remove a forward cross-beam of a motor compartment.
|
|
Fig. 3.4–4. Tension easing semi wedge a belt
|
Loosen the a tension semi wedge a belt, having turned a key the tension mechanism clockwise (fig. 3.4–4 see).
|
|
Fig. 3.4–25. Use шестигранного a key for fixing of the mechanism of a tension semi wedge a belt in the weakened position
|
For fixing of the mechanism of a tension semi wedge a belt in the weakened position insert шестигранный a key into fixing channels (fig. 3.4–25).
Remove полиwedge a belt and release the tension mechanism semi wedge a belt.
Installation
Installation is spent to sequences, return to removal, taking into account the following.
Establish полиwedge a belt at first on a pulley of a cranked shaft, then on single pulleys and in last turn on a pulley of a tension roller.
Start up the engine and check up correctness of work semi wedge a belt.
Establish a forward cross-beam.
|
|
Fig. 3.4–26. An arrangement semi wedge a belt on pulleys of the diesel engine
|
|
|