|
16-3-snyatie-i-ustanovka-vneshnego-sharnira-vala-privoda.html
16.3. Removal and installation of the external hinge of a shaft of a driveFix a drive shaft in a vice with soft sponges.
Remove collars of fastening of a protective cover and shift a cover from the hinge on a drive shaft.
Carefully clear an internal part of the hinge and remove a spring lock ring from the interior of the hinge.
Screw in the special tool 3207 in a shaft of the hinge and remove the external hinge from a drive shaft (fig. 10–5).
Remove a spring lock ring, a lining and тарельчатую a washer from the end of a shaft of a drive.
Fill the internal hinge with greasing.
|
|
Fig. 10–5. Use of the special tool 3207 for removal of the external hinge from a drive shaft
|
|
|
Fig. 10–6. Installation тарельчатой washers (1) and an intermediate ring (2) on a drive shaft
|
Establish on a drive shaft тарельчатую a washer the convex party to the hinge and an intermediate ring (fig. 10–6).
Establish on a drive shaft a new spring lock ring, fix a shaft in a vice with soft sponges and a hammer from a soft material press on the hinge on a shaft, thus a lock ring should enter accurately into a flute on a hinge inside.
Establish on the hinge a protective cover and fix its collars, a screw-driver preliminary having raised internal edge of a cover for alignment of pressure of air under a cover.
|
|
Fig. 10–7. Application of the special tool for collar fastening: And – the screw for an inhaling of sponges of the tool; In – installation of sponges of the tool on a collar
|
It is necessary to apply the tool to fastening of collars 1683 (fig. 10–7). Tool sponges establish on corners of a clip of a collar and in this position tighten sponges the screw.
|