21.5. Check of a rotor of gauge ABS
Loosen the bolts of fastening of forward wheels, then lift a forward part of the car and fix on supports. Remove a forward wheel.
Take from a rotary fist gauge ABS.
Fig. 15–3. Check of a condition of a rotor of gauge ABS through an aperture for gauge ABS installation
Turning a drive shaft, through an aperture for gauge ABS installation (fig. 15–3), gradually check up gauge ABS rotor on absence of damages and pollution.
In the presence of rotor damages it is necessary to replace an external SHRUS of a shaft of a drive.
If gauge ABS rotor is polluted, clear it of a dirt. For access to gauge ABS rotor unscrew a bolt of fastening of a shaft of a drive to a nave and move a shaft inside.
In no event it is impossible to lower the car on wheels with removed by two or one shaft of a drive as it will lead to damage of bearings of a nave of a wheel. If it is necessary to establish the car on wheels and to move it with the removed shaft of a drive, instead of a shaft establish an external SHRUS and tighten a bolt of its fastening by the moment 50 Нм.
Establish a drive shaft in a nave and fix its bolt, having tightened the moment 190 Нм and in addition having tightened on a corner 180 .